• Write a Review

Lag Screw Hook Zinc Plated 5/8in x 7-3/8in

# LH58L
In Stock
124 @ $ 4.69
> 25 @ $ 4.29
Weight: 0.700000 lbs
Zinc-plated with cone point. 5/8-inch by 7-3/8 inches. Remember: Lag threads are deep, coarse threads. When using hardware with lag threads, holes should be drilled 1/16-inch smaller than the lag size so that hardware can be threaded through the hole. This installation of lag rods will give holding power through the limb as well as on the outside. Using double nuts on the end of lag-threaded rods will allow installation with the driver.

Specs

5/8in. x 7-3/8in., left handed, zinc plated, cone point.

Review Summary

Customer Reviews for Lag Screw Hook Zinc Plated 5/8in x 7-3/8in

No Reviews

Zinc-plated with cone point. 5/8-inch by 7-3/8 inches. Remember: Lag threads are deep, coarse threads. When using hardware with lag threads, holes should be drilled 1/16-inch smaller than the lag size so that hardware can be threaded through the hole. This installation of lag rods will give holding power through the limb as well as on the outside. Using double nuts on the end of lag-threaded rods will allow installation with the driver.