• Write a Review

Right-Threaded, Zinc-Plated Lag Screw Hook

# LH58R
In Stock
124 @ $ 4.49
> 25 @ $ 3.99
Weight: 0.700000 lbs
Zinc-plated with cone point. 5/8-inch by 7-3/8 inches. Remember: Lag threads are deep, coarse threads. When using hardware with lag threads, holes should be drilled 1/16-inch smaller than the lag size so that hardware can be threaded through the hole. This installation of lag rods will give holding power through the limb as well as on the outside. Using double nuts on the end of lag-threaded rods will allow installation with the driver.

Specs

5/8in. x 7-3/8in., right handed, zinc plated, cone point.

Review Summary

Customer Reviews for Right-Threaded, Zinc-Plated Lag Screw Hook

No Reviews

Zinc-plated with cone point. 5/8-inch by 7-3/8 inches. Remember: Lag threads are deep, coarse threads. When using hardware with lag threads, holes should be drilled 1/16-inch smaller than the lag size so that hardware can be threaded through the hole. This installation of lag rods will give holding power through the limb as well as on the outside. Using double nuts on the end of lag-threaded rods will allow installation with the driver.